Forum

Author Topic: Building Tiled Model  (Read 4795 times)

Muhammad Khan

  • Newbie
  • *
  • Posts: 8
    • View Profile
Building Tiled Model
« on: March 01, 2019, 03:45:31 PM »
I have imported a fbx model generated from another software into Agisoft. I want to build a Tiled Model out of it but whenever I select the option it gives an error dialog box saying  "Can't Estimate Pixel Size". What is the meaning of this error? Is there any possible way to remove this error? Kindly Guide

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14004
    • View Profile
Re: Building Tiled Model
« Reply #1 on: March 01, 2019, 04:39:14 PM »
Hello Muhammad,

If you do not have aligned cameras which do overlap with the imported mesh, you wouldn't be able to generate the tiled model, as the operation of the tiled model creation assumes texture reconstruction for each block on every LOD level.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Muhammad Khan

  • Newbie
  • *
  • Posts: 8
    • View Profile
Re: Building Tiled Model
« Reply #2 on: March 04, 2019, 08:01:14 AM »
Okay, If I align the cameras in Agisoft for that mesh, Would I be able to generate Tiled Model using the imported mesh from other software?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14004
    • View Profile
Re: Building Tiled Model
« Reply #3 on: March 04, 2019, 12:17:10 PM »
Hello Muhammad,

Yes, if you have camera alignment that is referenced in the same coordinate space as imported mesh, then you would be able to generate the tiled model from it. Just make sure that the bounding box contains the imported mesh before you proceed to the tiled model generation procedure.
Best regards,
Alexey Pasumansky,
Agisoft LLC