Forum

Author Topic: Problem with Mesh output of PhotoScan scene with Metashape  (Read 2130 times)

OakCorp

  • Newbie
  • *
  • Posts: 20
    • View Profile
    • OakCorp
Problem with Mesh output of PhotoScan scene with Metashape
« on: March 27, 2019, 12:57:31 PM »
Loading a Photoscan project with Metashape 1.5 (1.5.2) and outputting an OBJ mesh results in no smoothing.

There is no problem with meshes generated from alignment in Metashape 1.5.

The normal is output to OBJ.

What is the cause?
« Last Edit: March 27, 2019, 01:01:01 PM by OakCorp »
--------------
OakCorp,
yuji yamauchi [senior tec support]

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Problem with Mesh output of PhotoScan scene with Metashape
« Reply #1 on: March 27, 2019, 01:52:42 PM »
Hello OakCorp,

I think that the issue is related to the coordinate information used. It looks like the model has been reverenced in some projected coordinate system with large Easting and Northing values for X and Y coordinates, then the model has been exported in the very same system, but the post-processing application cannot handle large values for coordinates and truncates some digits.

I can suggest to use Local Coordinates option on export or apply Shift for X and Y in the Export dialog to subtract large base values from the coordinates of the mesh vertices.
Best regards,
Alexey Pasumansky,
Agisoft LLC

OakCorp

  • Newbie
  • *
  • Posts: 20
    • View Profile
    • OakCorp
Re: Problem with Mesh output of PhotoScan scene with Metashape
« Reply #2 on: March 27, 2019, 03:21:15 PM »
thank you for the advice. I will try it.
I will explain that to my customer.

Best wishes,
-------
Yuji Yamauchi
OakCorp Support
--------------
OakCorp,
yuji yamauchi [senior tec support]