Adjust camera coordinates

[hudddi]

Hello everyone,
I would like to fit my aerial images on coordinates of the cameras. Now I have detected that the camera coordinates have an incorrect height with a constant delta height. Is it possible to set a GPS offset in Metashape before the analysis, so that my checkpoints fits after the evaluation?

Regards, hudddi

[JMR]

To amend camera altitudes, a simple trick it is to export cameras in ref pane, then copy camera lines paste file to an excel sheet, modify altitudes by adding whatever, and then import back in the same fashion. However, if this constant "error" comes truely from an offset between the gnss antenna and camera nodal point, then you can set it more properly in the camera calibration dialog.

Regards
GEOBIT

[hudddi]

Hi GEOBIT,

thanks for your response. I'll try your suggestions and if i have any questions about it, i will report.

Regards
hudddi