Forum

Author Topic: Adjust camera coordinates  (Read 2179 times)

hudddi

  • Newbie
  • *
  • Posts: 2
    • View Profile
Adjust camera coordinates
« on: June 17, 2019, 05:14:01 PM »
Hello everyone,
I would like to fit my aerial images on coordinates of the cameras. Now I have detected that the camera coordinates have an incorrect height with a constant delta height. Is it possible to set a GPS offset in Metashape before the analysis, so that my checkpoints fits after the evaluation?

Regards, hudddi

JMR

  • Hero Member
  • *****
  • Posts: 502
    • View Profile
Re: Adjust camera coordinates
« Reply #1 on: June 18, 2019, 06:34:31 PM »
To amend camera altitudes, a simple trick it is to export cameras in ref pane, then copy camera lines paste file to an excel sheet, modify altitudes by adding whatever, and then import back in the same fashion. However, if this constant "error" comes truely from an offset between the gnss antenna and camera nodal point, then you can set it more properly in the camera calibration dialog.

Regards
GEOBIT

hudddi

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Adjust camera coordinates
« Reply #2 on: June 24, 2019, 12:09:17 PM »
Hi GEOBIT,

thanks for your response. I'll try your suggestions and if i have any questions about it, i will report.

Regards
hudddi