Hi all
I have created a 3-D model of a small object (35 mm x 35 mm) to have some statistical measurements. My camera model is Nikon 3400D and I used a stepper motor to move the camera over my surface and have taken 30 photos of the surface. I placed the surface on a white table and used LED to illuminate the object. Camera settings are same for all 30 pictures. From the camera movement file, I imported the camera positions (coordinates) in photoscan instead of using any scale bar. In point cloud model I observed a lot of outliers which is causing error when comparing the data with the microscopic values (standard).
Does anyone have any suggestions? I have attached the photos in the link below.
https://imgur.com/a/2zVVw9KThanks !