Hello Photoscan/Metashape Community!
I am trying to create/digitize breaklines in the dense PointCloud.
That way, I can later produce a precise Mesh, where the breaklines are considered.
(I need a mesh from roads where the edges are precise - no trianlges going over the edges...)
However, when I am digitizing polylines in the dense pointcloud, the vertices aren't correctly picked.
I was trying to pick points from several views/directions, but the resulting polyline/breaklines always reside in the air (many centimeters above the actual points).
Is there any possibility to correctly pick points/vertices for the polylines? A sort of "snapping" would be convenient...
I will add some screenshots later to illustrate the problem...
Also: What is the general workflow to produce breaklines in Agisoft? Is there any?
I am testing VS (Virtual Surveyor) in parallel, but I would love to achieve theses tasks directly in Metashae/Photoscan....
Regards, Chris.