Forum

Author Topic: Problem "Not enough memory"  (Read 2692 times)

guicanarin

  • Newbie
  • *
  • Posts: 32
    • View Profile
Problem "Not enough memory"
« on: September 19, 2019, 04:30:16 PM »
Hi guys, i'm working with a Metashape Professional license and i have a Dense cloud with more than 500 millions points and a PC with 64 GB memory. When i wll make a mesh, i always watch the memory consuming. And in this case i have a pike of 54 GB memory consuming, but when the software was consuming 16 GB of memory, the error "Not enough memory" appears.
I wanna understand why this is happening!!

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Problem "Not enough memory"
« Reply #1 on: September 20, 2019, 12:56:43 PM »
Hello guicanarin,

Can you please specify the mesh generation parameters and provide the processing log related to the failed operation? Also please specify which type of the project you are working on?
Best regards,
Alexey Pasumansky,
Agisoft LLC