Forum

Author Topic: Crash with 51 seconds remaining in build geometry step  (Read 9092 times)

airmap3d

  • Jr. Member
  • **
  • Posts: 74
    • View Profile
Crash with 51 seconds remaining in build geometry step
« on: April 08, 2013, 11:46:18 AM »
Hello all,

Photoscan just crashed on me with only 51 seconds remaining in the build geometry step!  There was no reason given for this, it just said "Photoscan has stopped working and the program must close".  I have built geometry on this same project with the same settngs previously and it worked fine.

Any ideas as to what may have happened?  I am running Version 0.9.0 Build 1586 64bit.  Is it possibly a windows issue?  If this happens while working on a clients job it may become a bit of an issue!

Cheers,
Matt.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15160
    • View Profile
Re: Crash with 51 seconds remaining in build geometry step
« Reply #1 on: April 08, 2013, 12:17:49 PM »
Hello Matt,

Have you submitted the crash report or software just closed without any possibility to do that?
Best regards,
Alexey Pasumansky,
Agisoft LLC

airmap3d

  • Jr. Member
  • **
  • Posts: 74
    • View Profile
Re: Crash with 51 seconds remaining in build geometry step
« Reply #2 on: April 08, 2013, 12:34:42 PM »
Hi Alexey,

I didn't get a chance to do that, the program just closed.  Unfortunately I cannot give you any more details really.

Cheers,
Matt.

Wishgranter

  • Hero Member
  • *****
  • Posts: 1202
    • View Profile
    • Museum of Historic Buildings
Re: Crash with 51 seconds remaining in build geometry step
« Reply #3 on: April 12, 2013, 02:56:10 PM »
try enable logging permanently in settings....
----------------
www.mhb.sk