Forum

Author Topic: finding the cameras specific tie points came from  (Read 1071 times)

cronair

  • Newbie
  • *
  • Posts: 16
    • View Profile
finding the cameras specific tie points came from
« on: April 08, 2020, 08:44:18 PM »
I aligned my images and there are tie points in the model that obviously didn't align correctly but I can't tell which cameras produced those tie points so I can take them out of the alignment. How can I figure that out? This is an indoor project for fun using photos taken manually so it's a little harder to figure out than a typical outdoor aerial project. The shots are somewhat erratic.

Thanks!

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13990
    • View Profile
Re: finding the cameras specific tie points came from
« Reply #1 on: April 08, 2020, 09:15:27 PM »
Hello cronair,

You can select the incorrect tie points in the Model view and use Filter Cameras by Tie Points option from the context menu to leave only those images in the Photos pane which contain the projections of the selected tie points. Thus you can review them manually and decide, whether the alignment for them is incorrect.
Best regards,
Alexey Pasumansky,
Agisoft LLC