Forum

Author Topic: Misalignment  (Read 1175 times)

bestable

  • Newbie
  • *
  • Posts: 39
    • View Profile
Misalignment
« on: May 08, 2020, 05:19:41 PM »
What do You do when face misalignment issues like this:



Sometimes it is not that obvious but cause problems later- some wormholes in the model etc.

I tried to calibrate the camera but that seems to have no influence.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14004
    • View Profile
Re: Misalignment
« Reply #1 on: May 09, 2020, 02:00:12 AM »
Hello bestable,

You can select the tie points in the Model view related to the obviously incorrect areas, then filter the cameras by tie points and reset the alignment for all the related cameras. After all incorrect tie points have been filtered out using this approach, you can try to re-align the cameras with NA (Not Aligned) mark.
Best regards,
Alexey Pasumansky,
Agisoft LLC