Red_edge_dual_dense_pt_cloud_problem

[dowallin]

Greetings.

I am processing imagery from the Micasense Red Edge Dual Camera system. This generates a 10-band image. The data set includes 2170X10 tiffs covering a study area that is about 250 m by 2500 m. I have successfully run the reflectance calibration procedure and all of the images aligned. I have 28 GCPs. The sparse point cloud looks fine (jpg attached). When I run the dense point cloud procedure, the result has large holes in it (see attached JPG).

Any suggestions on how I can get a dense point cloud that covers the entire study area?

Regards,
David