Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Create contour by Shape or by Selection?
« previous
next »
Print
Pages: [
1
]
Author
Topic: Create contour by Shape or by Selection? (Read 3078 times)
Costas
Jr. Member
Posts: 70
Aerial Mapping
Create contour by Shape or by Selection?
«
on:
June 22, 2020, 02:21:57 PM »
Hello all.
i can create Contour Lines in a project just fine BUT I would like to create Contour Lines only in a small area from a project and i cannot seem to find a way to do that.
I tried to create a Polygon area and set the boundary type and then create the Contour Lines but the lines generated are from all the area covered by the project and not in the selected area.
Is there an easy solution to that (kind of generate by selection or something)? AND/OR is there any script available that can do just that? I'm not good at scripting so if there is a ready script available it would be much appreciated.
Thank you in advance for your help.
Logged
JMR
Hero Member
Posts: 515
Re: Create contour by Shape or by Selection?
«
Reply #1 on:
June 23, 2020, 10:04:00 AM »
Boundaries are used only at export time, so what if you export the dem limited to your boundary and then re-import it on the same chunk?
I guess it would work as you want.
Kind regards
GEOBIT
Logged
Costas
Jr. Member
Posts: 70
Aerial Mapping
Re: Create contour by Shape or by Selection?
«
Reply #2 on:
June 23, 2020, 11:58:03 AM »
Thank you for your answer JMR.
This worked nicely.
It would be great if we didn't have to do this (export/import) and had the option to do it "by selection" but until then it is a very good solution. Thank you again.
Best regards,
Costas.
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Create contour by Shape or by Selection?
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)