Workflow - Dense cloud generation ignoring masks

[546f6d6d79]

• Mask ~doz images
• Align images;
  
  • Generic
  • sequential
  • 60k Key
  • 0 Tie
  • Apply masks to tie points
  • Adaptive camera model fitting
• Refinement
• Build mesh - depth maps, high
• Import masks
  
  • from model
  • replacement
  • All cameras
• Build Dense cloud, reuse depth maps

It isn't too hard to clean up, but annoying cleaning fluffy fringing that was masked. They also make up 70% of the scene!
Should I be generating new depth maps when building the dense cloud?

edit: forgot to mention: turntable setup

[wojtek]

You might want to try different filtering mode on the dense cloud (but that would mean new depth maps).

[546f6d6d79]

I'd really been hoping to avoid recalculating the depth maps, but just finished re-running and surprisingly I didn't seem to lose any detail by setting filtering to agressive.
Think if I'd remembered to tick "calculate point confidence" and then filtering, it wouldn't have been a problem.

Thanks!

[JMR]

well, you can try now select dense points by mask and crop.
select by colour in your very case could also have good results.
Good luck
Geobit

[eltama]

I had same problem, now I try to build mesh from depth maps to see differences, I'll share result ASAP

[Alexey Pasumansky]

The masks are used during the depth maps generation. If they have been applied after the depth maps are calculated and the old depth maps are being re-used, the masks would not be applied.