Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
What if GCP references exist above the cameras?
« previous
next »
Print
Pages: [
1
]
Author
Topic: What if GCP references exist above the cameras? (Read 1143 times)
koriel-angelswing
Newbie
Posts: 22
What if GCP references exist above the cameras?
«
on:
August 13, 2020, 09:56:14 AM »
Hi, thank you always for good answering.
Recently, I faced the situation like the GCP references exist over the camera so that I could not filter photos my marker.
Is there any best practice for this?
Logged
KDSTanhope
Newbie
Posts: 10
Re: What if GCP references exist above the cameras?
«
Reply #1 on:
August 13, 2020, 11:27:49 AM »
If your markers project above the cameras you have an issue either with your extrinsic values (in this case the Z is incorrect) or your GCP Z is incorrect.
Alternatively the block is very poorly aligned.
What were your processing settings?
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
What if GCP references exist above the cameras?
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)