Forum

Author Topic: Cloud processing limits  (Read 2787 times)

rossnixon

  • Full Member
  • ***
  • Posts: 100
    • View Profile
Cloud processing limits
« on: November 29, 2020, 03:56:59 AM »
I have a project with about 116GB of aerial photos. After trying to upload to the Cloud, I discovered there is a 50GB limit. Should I divide them up into about three slightly overlapping areas? I'm only needing orthophoto tiles as final output. Would I just save the mesh from each of the three runs and then continue the process from my underpowered old PC?
« Last Edit: November 30, 2020, 08:17:02 AM by rossnixon »

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15118
    • View Profile
Re: Cloud processing limits
« Reply #1 on: November 30, 2020, 11:17:31 AM »
Hello rossnixon,

While Agisoft Cloud is working in beta-testing mode the default amount of disk space for the user account is 50 GB. If you require to extend the disk space for your account, please send the email to support@agisoft.com with the corresponding request from the email address registered in Agisoft Cloud.
Best regards,
Alexey Pasumansky,
Agisoft LLC

rossnixon

  • Full Member
  • ***
  • Posts: 100
    • View Profile
Re: Cloud processing limits
« Reply #2 on: November 30, 2020, 12:14:51 PM »
Thanks Alexey.
I have got one third of it processing at the moment. I will consider combining the other two-thirds for the next chunk later tomorrow, and will email my request then.