Forum

Author Topic: Change Coordinate System Setting  (Read 699 times)

WUOUXIANG

  • Newbie
  • *
  • Posts: 1
    • View Profile
Change Coordinate System Setting
« on: January 18, 2021, 01:19:05 PM »
Dear all :

The Default Coordinate System of Metashape is Y in vertical line.
However, After Adding and Aligning Drone Photo, it has become Z in vertical line.
What if I want to make object the unchanged(unrotated) , and change coordinate System to Y in vertical line (as default).
What Should I do ? thank you

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14004
    • View Profile
Re: Change Coordinate System Setting
« Reply #1 on: January 18, 2021, 02:20:04 PM »
Hello WUOUXIANG,

If you need to apply certain orientation to the processed project, you should use the coordinates of the camera locations or control points. For manual orientation of the model (if no referencing information is available) please use Rotate Object instrument in the Model view.
Best regards,
Alexey Pasumansky,
Agisoft LLC