Forum

Author Topic: display camera xyz after solving marker coordinates for use in camera selection  (Read 3991 times)

bisenberger

  • Sr. Member
  • ****
  • Posts: 329
    • View Profile
    • Digital Mapping & Graphics
After solving using ground control points (markers) it would be helpful if the camera xyz locations could be used for selecting cameras. This would be especially useful for selecting cameras based on altitude (z value).
« Last Edit: June 07, 2013, 09:39:44 PM by bisenberger »
Digital Mapping & Graphics LLC
https://digital-mapping.net/

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14765
    • View Profile
Hello bisenberger,

You can sort cameras by Estimated coordinates values in Ground Control pane by clicking on the column label.
Best regards,
Alexey Pasumansky,
Agisoft LLC

bisenberger

  • Sr. Member
  • ****
  • Posts: 329
    • View Profile
    • Digital Mapping & Graphics
Cool 8)
Thanks Alexey
Digital Mapping & Graphics LLC
https://digital-mapping.net/