Forum

Author Topic: incrimental align  (Read 280 times)

lunar

  • Newbie
  • *
  • Posts: 23
    • View Profile
incrimental align
« on: February 15, 2021, 01:17:29 PM »
Hi
When trying to add more photos to a project that is already aligned - the old points disappear - only those of the newly added photos are present - 1,71



Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 12508
    • View Profile
Re: incrimental align
« Reply #1 on: February 15, 2021, 07:16:52 PM »
Hello lunar,

I am not observing such problem on some random datasets.

Can you please confirm that initial alignment has been performed with Keep Key Points option enabled in the Advanced Preferences tab and that you are not selecting Reset Current Alignment option in the Align Photos dialog after adding new images to pre-aligned sub-set?
Best regards,
Alexey Pasumansky,
Agisoft LLC

lunar

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: incrimental align
« Reply #2 on: February 15, 2021, 08:56:20 PM »
in one project everything is ok, this happens after saving and reopening the project

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 12508
    • View Profile
Re: incrimental align
« Reply #3 on: February 15, 2021, 10:36:32 PM »
Hello lunar,

Can you please describe the steps, so that I could try to reproduce the issue?
- open new project,
- add images and align photos (with keep key points option enabled),
- save project,
- open new Metashape instance, open previously saved project,
- add new images and run align photos with "reset current alignment" option disabled.
It that correct?
Best regards,
Alexey Pasumansky,
Agisoft LLC

lunar

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: incrimental align
« Reply #4 on: February 16, 2021, 10:34:34 AM »
Yes, this happens when you open a previously saved project.
Working on one project from the beginning  - everything is ok

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 12508
    • View Profile
Re: incrimental align
« Reply #5 on: February 17, 2021, 05:43:52 PM »
Hello lunar,

Are there key points in the chunk (you can check it via Workspace pane -> Show Info) after you re-load the project?
Best regards,
Alexey Pasumansky,
Agisoft LLC

lunar

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: incrimental align
« Reply #6 on: February 18, 2021, 12:23:01 PM »
Hi
I can't repeat it myself this time - I uploaded the beta 1.72
Everything is ok

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 12508
    • View Profile
Re: incrimental align
« Reply #7 on: February 19, 2021, 05:55:51 PM »
Hello lunar,

If it happens again in latest Metashape version, please post here the procedure to be followed.
Best regards,
Alexey Pasumansky,
Agisoft LLC