Forum

Author Topic: Where did the camera rectangles go?  (Read 1698 times)

Brit

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
Where did the camera rectangles go?
« on: March 17, 2021, 01:00:56 AM »
Hello, for some reasons I'm missing those little rectangles that show the placement of the cameras after the alignment phase. Any suggestions?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Where did the camera rectangles go?
« Reply #1 on: March 17, 2021, 01:29:58 AM »
Hello Brit,

If you are in Model view mode, press Show Cameras button on the toolbar to make the camera placeholders appear. You may also need to use Reset View button, if you do not see anything in the Model view after processing operation is completed.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Brit

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
Re: Where did the camera rectangles go?
« Reply #2 on: March 19, 2021, 01:45:25 AM »
Thanks!