Forum

Author Topic: Camera correction and pitch roll yaw input values used for alignment yet?  (Read 5942 times)

flightfollowing

  • Newbie
  • *
  • Posts: 9
    • View Profile
Are the values of pitch, roll, yaw, and X Y Z (offset?) input in the Camera Correction screen of alignment enabled in 0.9.1?
I have precise values for these parameters (quality GPS/IMU) and seem to be getting mixed results in enabling camera correction for the alignment output when using them. Does anyone know if this is enabled, and if so, best strategies to use it?
For example, if the pitch error from input values to output values in a good project is about a 1 degree offset, ( 1 degree plus or minus about 1 degree)  is it useful to enter a pitch correction of 1 degree (or 179 degrees since the initial is always 180 degress?) in the same project or subsequent projects using the same GPS/IMU geometry?
This post is somewhat an extension of post:
http://www.agisoft.ru/forum/index.php?topic=370.0

which indicated camera correction was not enabled back in 0.8.5

Thanks

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15124
    • View Profile
Hello flightfollowing,

Camera correction section in Ground Control pane setting dialog is working, but effects only on estimated orientation angles.
Source values for orientation angles are not used in processing for 0.9.1 version.
Best regards,
Alexey Pasumansky,
Agisoft LLC