Forum

Author Topic: Decimate Mesh - Selection Only - Not working  (Read 2959 times)

TarickTDS

  • Newbie
  • *
  • Posts: 2
    • View Profile
Decimate Mesh - Selection Only - Not working
« on: June 04, 2021, 04:31:12 AM »
Wat's up crew!!!  :o

to reproduce;
select a section of your model
run the decimate mesh command with selection only
result: entire mesh is decimated
expected: only selection to be decimated

Peace all!!!  ;D

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15122
    • View Profile
Re: Decimate Mesh - Selection Only - Not working
« Reply #1 on: June 04, 2021, 02:57:28 PM »
Hello TarickTDS,

Which version of Metashape you are using?

I've tried to reproduce it in 1.7.3 version on random model, but it worked as expected.
Best regards,
Alexey Pasumansky,
Agisoft LLC

TarickTDS

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Decimate Mesh - Selection Only - Not working
« Reply #2 on: June 05, 2021, 08:44:49 AM »
I believe it was 6.6 ish.

Just realised there is an update.