Forum

Author Topic: Error: Can't align cameras  (Read 3361 times)

SuperNewb

  • Newbie
  • *
  • Posts: 42
    • View Profile
Error: Can't align cameras
« on: July 14, 2021, 06:13:01 AM »
Hi guys,
I have just installed version 1.73.12473 professional.  Also I have swapped to a new gpu, an rtx 3080ti.  I have tried running a few photo sets through, and each time, during image alignment, Metashape pops up with this error and no aligned cameras....  These datasets were processed in previous versions and before the gpu switch.

Anyone having the same issue from the new version or from a similar gpu?

I have attached the console report as well.  It looks as though everything is fine until it reaches the stage where it is trying to match points using the gpu and it comes up with 0.


Thanks,


Solved: I took a better look at the forums here and learned about the 0 limit not working when aligning photos, My tie points and key points were both set at 0, changing this to a high number fixed this
« Last Edit: July 14, 2021, 06:20:13 AM by SuperNewb »

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14816
    • View Profile
Re: Error: Can't align cameras
« Reply #1 on: July 14, 2021, 03:14:28 PM »
Hello SuperNewb,

Yes, it's a known issue in 1.7.3 version, which doesn't allow to use zero value for key point limit.

The issue will be fixed in 1.7.4 version.
Best regards,
Alexey Pasumansky,
Agisoft LLC