Forum

Author Topic: mesh appeared to "explode"  (Read 833 times)

Brit

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
mesh appeared to "explode"
« on: July 09, 2021, 02:06:10 AM »
For some reason my seemingly normal dese cloud of a high Utah ridge scan seemed to "explode" with hundreds of small spheres floating around the ridge, which was ill defined when the bits were removed. Any ideas?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14003
    • View Profile
Re: mesh appeared to "explode"
« Reply #1 on: July 09, 2021, 02:16:50 AM »
Hello Brit,

Which Metashape version do you use and which mesh generation settings have been selected in this project?

Also please specify, if the alignment results are correct, or whether you see that some cameras are aligned incorrectly or even the alignment is split into several poorly connected components.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Brit

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
Re: mesh appeared to "explode"
« Reply #2 on: July 09, 2021, 03:36:49 AM »
>"Which Metashape version do you use and which mesh generation settings have been selected in this project?

It's 1.7.1. I'm updating now.

>Also please specify, if the alignment results are correct, or whether you see that some cameras are aligned incorrectly or even the alignment is split into several poorly connected >components."

I'm not quite sure what this means. How do I know if they are correct?

Do I optimize cameras?