Forum

Author Topic: Port zoom from Agisoft Viewer to Agisoft Pro  (Read 1839 times)

nola

  • Newbie
  • *
  • Posts: 9
    • View Profile
Port zoom from Agisoft Viewer to Agisoft Pro
« on: October 15, 2021, 01:12:00 PM »
Hi,

I find that the zoom feature in Agisoft pro can be difficult to use when I zoom in very close to the model as the mouse controls (rotate, pan) seem to have a center of rotation that is not within the viewframe (hope you can understand what I mean). This results in the model 'disappearing' from the view frame with small rotations of the model.

I just tried Agisoft Viewer as I needed to share a model and was really happy to find that the zoom in controls work wonderfully! So my request is, could you port the Viewer Zoom controls over to Agisoft Pro?

CheeseAndJamSandwich

  • Full Member
  • ***
  • Posts: 153
    • View Profile
    • Sketchfab Models
Re: Port zoom from Agisoft Viewer to Agisoft Pro
« Reply #1 on: October 15, 2021, 07:09:18 PM »
After zooming, double click on the model/point and this will set the centre of rotation on that surface/point...  it'll centre what you double-clicked on to the centre of the viewport...  Then i'll move around as expected.

You might then get foreground stuff whizzing past, or you'll see clipping of stuff too near or far.
This is fairly standard behaviour with most 3D applications i think.