Forum

Author Topic: UV map only shows part of mapping  (Read 3142 times)

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
UV map only shows part of mapping
« on: September 27, 2021, 04:57:29 PM »
Hi,
when I generate texture and look at the exported texture it only shows part of the map. The 3D model is a cup and looks fine with texture so that's not the problem. On the jpg I can only see part of the outside and smaller part of the inside. So...where can I find the rest? It must be somewhere, cause it's showing on the 3D model. anyone knows what's going on?
thanks
René

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15145
    • View Profile
Re: UV map only shows part of mapping
« Reply #1 on: September 27, 2021, 08:15:12 PM »
Hello René,

How many texture atlas pages have been generated for this project?

If there are multiple texture pages, you can switch between them via Tools Menu -> Mesh -> View Mesh UVs dialog.
Best regards,
Alexey Pasumansky,
Agisoft LLC

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
Re: UV map only shows part of mapping
« Reply #2 on: September 27, 2021, 11:27:25 PM »
Hi Alexey,
that's probably the one.
and I've got 960 camera's in the project. comming from 2 merched chunks.

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
Re: UV map only shows part of mapping
« Reply #3 on: September 28, 2021, 09:59:19 AM »
I must appologize for my question. I drew some lines over the exported map and imported again, and the lines showed up all over the 3D model! so the map is the full map. I couln't imagine it was the full map, but here you go. so sorry for the question asked.
regards,
René

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15145
    • View Profile
Re: UV map only shows part of mapping
« Reply #4 on: September 28, 2021, 02:05:05 PM »
Hello René,

Can you provide the screenshots of the textured model (from the opposite sides)?
Best regards,
Alexey Pasumansky,
Agisoft LLC

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
Re: UV map only shows part of mapping
« Reply #5 on: October 01, 2021, 06:27:43 AM »
Hi Alexey,
as I stated, my mistake, it worked out anyway.
But thanks
regards,
René