Have a question about holes on a few orthophotos after I export Orthomosaic.
When I build an orthomosaic, I can see no problems at all BUT...
When I review each orthophoto, I found a few holes and wonder why what can cause that ?
I have been trying to figure it out how to fix it but no luck.
When I use orthomosaic the settings I set are follow as :
Coordinate System : NAD83/ UTM zone 13N (EPSG:26913)
Rater: Leave as Pixel Size (m)
Region : Leave as Total Size (pix)
Enable Write title Scheme:
Compression TIFF compression as Deflate
JPEG Quality as 90
Enable as Write tiled TIFF
Enable as Generate TIFF overwrite
Use JPEG 2000 to export both orthophotos and Orthomosaic
Same area overlaps.
When I export orthomosaic and show the same as orthophoto I show you does not have holes.
Do you know what may be causing it ?
Thanks