Forum

Author Topic: zero tie points  (Read 2663 times)

JMR

  • Hero Member
  • *****
  • Posts: 502
    • View Profile
zero tie points
« on: October 22, 2021, 01:04:58 AM »
Recently my colleague Simon Brown has had this weird issue. Right after aligning successfully a set of photos, there is no region and no tie points. How is this possible?
Repeating alignment has worked again as usual.
I'm lost.

JMR

Paulo

  • Hero Member
  • *****
  • Posts: 1303
    • View Profile
Re: zero tie points
« Reply #1 on: October 22, 2021, 02:12:27 AM »
Heloo JMR,

it seems that the alignment only did the matchPhotos stage and not alignCameras.

I would recommend to type following in console:
Code: [Select]
Metashape.app.document.chunk.alignCameras()
and you should get a correct alignment.

Good luck,
Best Regards,
Paul Pelletier,
Surveyor

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: zero tie points
« Reply #2 on: October 22, 2021, 05:28:38 PM »
Hello José,

Do you observe any similar problem for different projects? And if so, are those issues reproducible in Metashape 1.7.5?
Best regards,
Alexey Pasumansky,
Agisoft LLC

JMR

  • Hero Member
  • *****
  • Posts: 502
    • View Profile
Re: zero tie points
« Reply #3 on: October 25, 2021, 01:12:01 PM »
Seen at least 3 times with 1.7.4, the issue required built tie points command and everything worked as expected.
not yet seen/tested with 1.7.5

Thanks
GEOBIT

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: zero tie points
« Reply #4 on: October 25, 2021, 02:26:25 PM »
Hello José,

If you observe the same issue in 1.7.5, please save a copy of problematic project and share to our support e-mail address, so that we could analyze it.
Best regards,
Alexey Pasumansky,
Agisoft LLC