Forum

Author Topic: View - Reset View is broken...  (Read 2039 times)

CheeseAndJamSandwich

  • Full Member
  • ***
  • Posts: 153
    • View Profile
    • Sketchfab Models
View - Reset View is broken...
« on: November 05, 2021, 10:22:53 AM »
If we press 0, or choose Reset View from the View menu, it changes the viewport's view to a top view, but one that is not centred correctly, and it's zoomed in too far, such that it crops off a lot of the point cloud, mesh, whatever, that's currently being viewed.  So, unlike the other view shortcuts, 1, 3, 7, etc. it proves not to be useful... It's actually quite annoying.

What is Reset View resetting to???  It's a mystery.
From the Metashape manual:
Quote
Resets the viewport to display the complete model or photo.
But it doesn't.  No matter what you change, you can't persuade it to show what you want, following any kind of logic.
It doesn't seem to be related to the grid, or to 0,0...

What should Reset View actually reset to?
It does reset to top view.  Which would be correct.
I'd say that it should reset the zoom to show all of the point cloud, mesh, etc. plus a small empty margin around them.  Pretty standard I'd say.
Should it reset the zoom to the extents of things that are currently not visible?  This could be desirable both ways.  Perhaps an preferences option, or tweak could allow either?

What shouldn't Reset View rest to?
Apparently, if there's camera tracks, for doing animations, then it changes the Reset View...  But not in a logical way, and it does so even when the track isn't visible, which it isn't by default.  The camera track would only need to be viewed at very specific times, and surely the user can just zoom out for them.  So Reset View should ignore these.
It seems to be influenced by the Region, but again, it doesn't zoom out to to show all the region that is set.  And the region is often set well outside of the extents of the data, point cloud, mesh, etc...  And is often set to not be visible.


Please can we have it just reset to top view, and zoom to show the extents of the point cloud, mesh, etc?

Thanks.
« Last Edit: November 06, 2021, 03:10:08 PM by CheeseAndJamSandwich »