Forum

« previous next »
Pages: [1]

Author Topic: resetting predefined views  (Read 2532 times)

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
resetting predefined views
« on: December 07, 2021, 04:46:51 PM »
after reorienting the view, objects and the grid to xz I've got my Y axis the way I want it.... to the top. But the predefined views are wrong now. 7 should show topview, 1 front. etc.
is there a way to set these right so I can use them the way i'm used to?
Logged

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15029
    • View Profile
Re: resetting predefined views
« Reply #1 on: December 07, 2021, 06:33:53 PM »
Hello renevg,

Can you post a couple of screenshot for better understanding of the problem?

Top means TopXY, Front - FrontXZ and etc.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
Re: resetting predefined views
« Reply #2 on: December 07, 2021, 06:56:22 PM »
what is alright now: Y axis is pointing up and grid is xz, but the keyboardshortcuts are wrong now. "7" shows side instead of top, "1" shows bottom instead of front etc.
Logged

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15029
    • View Profile
Re: resetting predefined views
« Reply #3 on: December 07, 2021, 06:59:32 PM »
Hello renevg,

Metashape is using Z-up convention, so Top view option means that the camera is looking parallel to Z axis to XY plane.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC

renevg

  • Newbie
  • *
  • Posts: 39
    • View Profile
Re: resetting predefined views
« Reply #4 on: December 07, 2021, 07:05:42 PM »
Yes, has always been that way. some 3D programs use Y axis as up, so to standardize the files I would like to be able to use the 'right' side up. I guess this is as far as it goes..... everything works for me except the views. Would be nice if I could rename them.
Logged
Pages: [1]
« previous next »