Forum

Author Topic: Source Mesh for Reduce Overlap  (Read 1313 times)

IanJohnson

  • Newbie
  • *
  • Posts: 33
    • View Profile
Source Mesh for Reduce Overlap
« on: December 15, 2021, 06:46:40 PM »
How is the mesh used to calculate which images should be disabled for Reduce Overlap?  If I build a mesh from sparse cloud and reduce overlap, more photos are disabled than if I reduce overlap using a mesh built from low quality depth maps. 

I'm trying to figure out how much I can reduce overlap without getting holes.    Is the calculation more accurate using depth maps?  Does the quality of the depth maps matter?  If I reduce overlap, then build the model again with low quality depth maps, would that give me a heads up about where I will have holes in the final mesh?