Camera Calibration Parameter Agisoft Different from Matlab

[lyhour]

Hello everyone! I have been calibrated my camera using Matlab. After that, I use the calibrated parameter from Matlab to input in Camera calibration in Agisoft. When I align the photo, it gives me the inaccurate result. I notices that the Agisoft has the camera calibration function. Therefore, I conducted it. It gives me the acceptable result after finish alignment of photo. However, the result of calibration parameter is different. I want to know why it is different of calibration ? and how Agisoft determine the calibration parameter. My camera model is industrial camera IDS with 4mm focal length. Thank you very much.

[Paulo]

Hello Lyhour,

could you give an example of camera parameters obtained from Matlab calibration and example of parameters obtained from Metashape calibration. So we can compare. I am assuming you are doing a close range checker board type calibration in both cases.
Definition of different intrinsics parameters can vary between these calibration methods...

Hope to hear from you,