Author Topic: Imported mesh will not show in Version 0.8.2 (Read 7576 times)

c.lopez · « **on:** June 15, 2011, 08:57:20 PM »

Hello!

When a mesh is imported into version 0.8.2 it will give a face count of 0 and will not show.

The same mesh shows fine into 0.8.1

Diego · « **Reply #1 on:** June 16, 2011, 04:46:37 AM »

Hello Cesar Lopez,

You must use the Bug Reports section and you will see that this has already been published:

http://www.agisoft.ru/forum/index.php?topic=136.msg574#msg574

It also helps maintain order.

Regards,

Diego

Forum