Which is best metashape version to install considering bugs etc ?

[Steve003]

Hi,
 I am with 1.7.1 and had holes in mesh , and some images not aligned, even when they were ok in a prior chunk, when photoscan was used on the same images it was perfect.
I see folk with holes and gripes in 1.8.0, as such I avoided 1.8.0
I now see we are with 1.8.1.
is the .1 the fix to 1.8.0 issues ?

ARE WE AT LAST WITH A STABLE DEPENDABLE PROGRAM as all went ill with 1.7

If not why not after over 6 months ? we have work to do.

is the pro version fine and the standard ill ?

WHAT VERSION IS BEST TO INSTALL FOR STABILITY AND EQUAL TO DEPENDABILITY OF PHOTOSCAN ?

There is no point in having the speed and navigational advances of metashape if its bad.

I have just fed it a lovely set of images, all were aligned, that was a good start, but then a complete mess resulted, just a few blobs, dense cloud looked like an explosion in a hay bale, worst ever.

Loads of 'added ' feature in the Agisoft hype, but what of these basic fundamental problems, certainly why can photoscan align and not reject far better and not make holes ? (just terribly slow)

I havent been able to use Agisoft metashape awaiting fixes for many months.

Also still awaiting tech feedback, normally very good, not heard a thing after 6 months.

WORRIED !

Steve