Forum

Author Topic: Rapid Orthomosaic  (Read 1088 times)

MurrayW

  • Newbie
  • *
  • Posts: 17
    • View Profile
Rapid Orthomosaic
« on: May 24, 2022, 12:55:42 PM »
Hi everyone,

I am looking for a method to generate a quick orthomosaic, so color can be checked and adjusted prior to the final mosaic.

I have 5400 images from FujiFilm GS100 100 MegaPixels)

I have psx project with 1100 of the 5400 images. It is aligned, optimised, Dense Pt Cld, Mesh, all ready to go to mosaic - that takes 7 hours.
But the colors differences between images are large due different dates, sun-angle, atmospheric conditions, etc.

I made some low resolution images, and made a new psx with those.
I did the  usual process and could generate a low-res mosaic in 2 minutes

I would like to import the EO (XYX/OPK.csv) from the accurate high-resolution psx - in place of the whole allign/optimise etc process with the low-res images

I hope to import and accept the EO
Also import a mesh or DEM, create a camera calibration, then run mosaic

But not sure how to tell metashape to accept the imported EO.


MetaSHape 1.7.5 build 13229 (64 bit)

regards

Murray


Paulo

  • Hero Member
  • *****
  • Posts: 1303
    • View Profile
Re: Rapid Orthomosaic
« Reply #1 on: May 24, 2022, 04:27:47 PM »
Hello MurrayW,

you can look at  https://github.com/agisoft-llc/metashape-scripts/blob/master/src/quick_layout.py. This let's you set the EO of images according to imported reference values (XYZ YawPitchRoll)...

it should get you going
Best Regards,
Paul Pelletier,
Surveyor