Placing control points

[Joseal78]

Hi everybody:

I've been doing some orthomosaics using control points. One question that always come to my mind when I'm placing them in the photos is that sometimes the mark of the ground control point is not clearly visible and because ot that it's not so simple to place the marker . Do you recommend to leave it like that without any adjustment or try to fix it to any potential mark on the ground?

[dpitman]

I skip adjusting the point in photos where it is not clear.  If you are not getting at least 4 or 5  good clear alignments you might need to adjust where or how you are laying out your control.

[DayGeckoArt]

If it's not clear I block the control point so it doesn't mess up the model

[Joseal78]

I skip adjusting the point in photos where it is not clear.  If you are not getting at least 4 or 5  good clear alignments you might need to adjust where or how you are laying out your control.

OK, thanks.

[Joseal78]

If it's not clear I block the control point so it doesn't mess up the model

Thanks, I'll do the same.