Forum

Author Topic: Crash on matching images  (Read 650 times)

igor73

  • Full Member
  • ***
  • Posts: 228
    • View Profile
Crash on matching images
« on: June 24, 2022, 12:54:15 PM »
Trying to align 44000 images but it crashes a few minitues in to the process.  Latest Metashape.  Full log file attached.  What is the cause?

2022-06-24 10:42:18 QPainter::end: Painter not active, aborted
2022-06-24 10:42:18 QPainter::begin: Paint device returned engine == 0, type: 3
2022-06-24 10:42:18 QPainter::setCompositionMode: Painter not active
2022-06-24 10:42:18 QPainter::end: Painter not active, aborted
2022-06-24 10:42:18 QPainter::begin: Paint device returned engine == 0, type: 2
2022-06-24 10:42:18 QWidget::render: Cannot render with an inactive painter
2022-06-24 10:42:18 QPainter::begin: Paint device returned engine == 0, type: 3
2022-06-24 10:42:18 QPainter::setCompositionMode: Painter not active
2022-06-24 10:42:18 QPainter::end: Painter not active, aborted
2022-06-24 10:42:18 QPainter::begin: Paint device returned engine == 0, type: 3
2022-06-24 10:42:18 QPainter::scale: Painter not active
2022-06-24 10:42:18 QPainter::setRenderHint: Painter must be active to set rendering hints
2022-06-24 10:42:18 QPainter::end: Painter not active, aborted
2022-06-24 10:42:18 QPainter::begin: Paint device returned engine == 0, type: 3
2022-06-24 10:42:18 QPainter::setCompositionMode: Painter not active

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13789
    • View Profile
Re: Crash on matching images
« Reply #1 on: June 24, 2022, 05:15:07 PM »
Hello Igor,

Do you have the same problems, if you temporarily remove all the autostart scripts before running Metashape?

Also please check, if there's any unusual output to the Console pane, when you open GPU Preferences tab in Metashape run on the same machine?
Best regards,
Alexey Pasumansky,
Agisoft LLC

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13789
    • View Profile
Re: Crash on matching images
« Reply #2 on: June 24, 2022, 10:03:33 PM »
Hello Igor,

If it would be possible, can you please check the following: close Photos pane in the active Metashape window and after that run the same Align Photos procedure, that crashed before on the same machine.
Best regards,
Alexey Pasumansky,
Agisoft LLC