Forum

Author Topic: Build cylindrical Orthomosaik - Location of marker is undefined  (Read 3127 times)

Dieter

  • Full Member
  • ***
  • Posts: 198
    • View Profile
I want to build a cylindrical Orthomosaik with three markers. Axis is marker 1 to 2. Projection origin is marker 3.

After starting the procedure, a failure "Location of marker 1 is undefined." expires.


I´ve done this several times, why is there a failure? Version is 1.8.1 build 14671.


See screenshot!

Antonis

  • Newbie
  • *
  • Posts: 1
    • View Profile
Re: Build cylindrical Orthomosaik - Location of marker is undefined
« Reply #1 on: April 13, 2023, 11:26:38 AM »
hello, the solution to your problem is that you might have 2 local coordinates system. If you try to select it with the selection tool the marker should be selected. If not you have to convert the reference system to the second local coordinate system. Be carefull with the reference!!!

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14816
    • View Profile
Re: Build cylindrical Orthomosaik - Location of marker is undefined
« Reply #2 on: April 13, 2023, 02:09:53 PM »
"Location of marker 1 is undefined" message could be related to some bug in 1.8.1 version, that has been fixed in the later versions.
It should be possible now to use the 3D markers defined by 2+ projections on the aligned images and also markers without any projections, but checked on in the Reference pane with the input coordinates to the source values tab.
Best regards,
Alexey Pasumansky,
Agisoft LLC