Forum

Author Topic: Problems aligning big Dataset in one aligment  (Read 1244 times)

4DS Niklas

  • Newbie
  • *
  • Posts: 9
    • View Profile
Problems aligning big Dataset in one aligment
« on: August 03, 2022, 11:16:29 PM »
Hello everyone,

i have a dataset of ~2400 images capturing a schoolbuilding.

When trying to align these images, only 1750 got aligned in one attempt. I aligned the others in 2 seperate chunks, which worked fine.
I planned to try to align the chunks together using Align Chunks point based, but it also did not seem to work.

I have 2 chunks containing images capturing the buildings facades at low distances at mostly 0°, and one chunk capturing the building from above at -90° to roughly -50°.
In my experience, the overlapping areas should be more than enough to get the images to align in one go, but i cannot seem to get it working.
Any ideas what i could do differently to get these images to align in one go?
I attached images of the chunks where i marked the same facade in each for better orientantion.

GGR

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: Problems aligning big Dataset in one aligment
« Reply #1 on: August 05, 2022, 09:35:38 AM »
You can try to place markers and align your chunks with those. Or to register your clouds with the ICP tool implanted on CloudCompare.
Best regards
Gabriel

PolarNick

  • Jr. Member
  • **
  • Posts: 97
    • View Profile
Re: Problems aligning big Dataset in one aligment
« Reply #2 on: August 05, 2022, 10:31:36 AM »
What parameters did you use for alignment in one processing? (you can just click on Tie Points of that attempt and make a screenshot - parameters of alignment will be shown in bottom left corner)