Two chunks changes the colour of the final model

[Tony_Richards]

Hello all,

I pop in and out of photogrammetry at work every six months or so. This latest model is bugging me.

When I make the texture with one chunk of the upper areas of this casket it looks acceptable.

When I try to add the bottom section either as another chunk or all thrown into the pot together then the upper section/lid becomes washed out? The bottom was captured by turning the item upside down closed on a turntable and then unwanted info masked out. Pics attached.

Any suggestions appreciated.

Thanks
Tony

[Alexey Pasumansky]

Hello Tony,

I think that you need to look through the images which contain the unmasked areas related to the "washed out" model's texture part - probably additional masking is required.

[Tony_Richards]

Hi Alexey,

Thats what I cant understand. The bottom section/underneath of this chest is fully masked/cut out in PS as is the upper images.
So I cant see where this additional whiteness is coming from when the lower images are added. Its never happened before.

Thank you for the reply.

Tony

[Alexey Pasumansky]

Hello Tony,

Can you share a project copy (to support@agisoft.com) that contains aligned camera locations, tie points, textured mesh model (with the issue) and image thumbnails for all cameras?

[Tony_Richards]

Hi Alexey,

I think I figured it out. As I mentioned I only pop in and out of photogrammetry every 6 month or so. Seems I hadn't imported my masks!!! Schoolboy error.

Thank you,
Tony