Forum

Author Topic: Inverted surface model  (Read 3211 times)

Viking69

  • Newbie
  • *
  • Posts: 9
    • View Profile
Inverted surface model
« on: September 01, 2013, 01:34:01 AM »
I am exporting the model as a DXF file. When I open it other software the surface is inverted. ie the high elevations are shown as lows. If I develop a point cloud of a hill, it exports as a depression.

Suggestions?

Thanks!

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Inverted surface model
« Reply #1 on: September 01, 2013, 03:00:31 PM »
Hello Viking69,

Could you please specify if the model orientation is the same (inverted) in PhotoScan model view (Z axis pointing "down")? If yes, than probably you have not referenced your model using Ground Control pane or X-coord and Y-coord columns were mixed.
Best regards,
Alexey Pasumansky,
Agisoft LLC