Forum

Author Topic: incomplete point selection in point clouds  (Read 830 times)

Kiesel

  • Sr. Member
  • ****
  • Posts: 332
    • View Profile
incomplete point selection in point clouds
« on: November 23, 2022, 10:49:24 AM »
Dear Agisoft team,

I have difficulties with the current selection tool for a long time, especially when I work with deeper point clouds like imported laserscans. The current selection tool seams to be restricted to depth, so I have to select again and again the same area to a deeper and deeper space up to ten times and more and even then I can't be sure that I have selected all points in this area, because when I zoom out some "new" points arise. And in this outzoomed view it is of course more difficult to make a precise selection.  Have I overseen something? I hope for a solution soon for an otherwise nice product.

Best regards,

Kiesel

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: incomplete point selection in point clouds
« Reply #1 on: November 23, 2022, 04:10:39 PM »
Hello Kiesel,

Can you please check, if Visible Selection is enabled in the drop-down menu on the Toolbar for the selection tools?
Best regards,
Alexey Pasumansky,
Agisoft LLC

Kiesel

  • Sr. Member
  • ****
  • Posts: 332
    • View Profile
Re: incomplete point selection in point clouds
« Reply #2 on: November 24, 2022, 10:02:46 AM »
Hello Alexey,

yes indeed  :-\ Visible Selection was ticked on in Selection Tools (even I haven't done that), thanks!


Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: incomplete point selection in point clouds
« Reply #3 on: November 24, 2022, 12:07:59 PM »
Hello Kiesel,

We will make sure that Visible Selection is unchecked by default in the next version updates.
Best regards,
Alexey Pasumansky,
Agisoft LLC