Forum

Author Topic: Mesh gets strange, what am i doing wrong?  (Read 798 times)

Mr.Vain

  • Newbie
  • *
  • Posts: 31
    • View Profile
Mesh gets strange, what am i doing wrong?
« on: December 05, 2022, 08:35:44 PM »
Hi!

After updating i must have changed something in my settings when creating a mesh but i can figure out what settings. Before my update i did not get many holes even if i had some trees in the cloud and the edges of the mesh was not like it is now, like a wall. I have tried a lot of diffrent settings but i get the same. Anbybody have a idea of what settings to use for creating the mesh to avoid getting holes and a wall at the edge?


Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14965
    • View Profile
Re: Mesh gets strange, what am i doing wrong?
« Reply #1 on: December 07, 2022, 07:39:16 PM »
Hello Mr.Vain,

What processing parameters you are using for mesh generation? Also please specify, what what the previous Metashape version that you have been using before update and what is the version number that you are using now?
Best regards,
Alexey Pasumansky,
Agisoft LLC