Forum

Author Topic: Disable edge “skirt”  (Read 862 times)

brrarmboolay

  • Newbie
  • *
  • Posts: 9
    • View Profile
Disable edge “skirt”
« on: December 08, 2022, 06:51:29 AM »
Hi

I have a point cloud that’s pretty much 2.5d. I process it with metashape and it trys to figure out the edges which is not good for volumetric video. I want it to stop trying to process the edges, or stop trying to mesh where there aren’t enough points to make accurate mesh.

It has this kind of “skirt” around the whole edge of the mesh, if you look at the video it should be clear what I’m trying to remove.

Thanks for you help

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14965
    • View Profile
Re: Disable edge “skirt”
« Reply #1 on: December 09, 2022, 03:22:08 PM »
Hello brrarmboolay,

Can you please share the link to the video or at least a few screenshots demonstrating the problem?

Also please specify Metashape version that you are using and processing parameters for Align Photos, Build Dense Cloud (if applicable) and Build Mesh operations.
Best regards,
Alexey Pasumansky,
Agisoft LLC