I built a mesh from a point cloud, it took forever, and when it was finally done there was an error saying that it couldn’t write the file as there wasn’t enough space on my device. I’ve now cleaned up my computer, deleted a lot of things so there should be enough storage for the file now. My question is: Is it possible to somehow “re-write” the file without having to start all over with the building of the mesh? I’m thinking since it says “100% finished” in the job list, so it sounds like the actual building of the mesh was successful, it just wasn’t able to “write it”? You’ll have to excuse me if this is a stupid question, I’m not super tech-savvy with this stuff.