Batch Process Linux 64 build 985

[KEgg]

Hi guys,

I've tried to use the batch processing on the Linux version. Went through setting up the chunks to be processed. Each chunk has masks applied to 8 images, an imported camera calibration and alignment points generated before doing a batch geometry build.

So i set off the batch process, and off it goes doing the first of what should be many depth reconstructions. It gets to the end of doing the first depth recon, and just sits there. Eventually, a good half hour after it got to 100% of the depth recon, I had to kill it.

any ideas?

best regards

MikeH

[Alexey Pasumansky]

Hello Mike,

We have checked the same operation on Ubuntu 10.04 and it worked fine. Does this problem occurs regularly with this set of chunks and images?
You can send us this data, so we could try to find out what is the problem.

[KEgg]

Hi Alexy,

It seems to always crash, but random as to when. Just tried again and it crashed 10% into depth recon of first chunk. Have also reported this via the crash reporter.

I could send u the same data set, but I'm not sure the client would like this.

best regards

Mike

[Alexey Pasumansky]

Hello Mike,

We have received  your crash reports and it seems that the problem is with the OpenCL acceleration. Can you please try to disable it in "Preferences"?

[KEgg]

Hi Alexey,

Have done as suggested, and its working perfectly, if a little slower. Hope the openCL is not to much of an issue to solve, or could it be related to the machine which is currently using a 8800GTX while I get the GTX480 replaced?

best regards

MikeH