Forum

Author Topic: Masks for laserscans not working  (Read 2900 times)

Dieter

  • Full Member
  • ***
  • Posts: 209
    • View Profile
Masks for laserscans not working
« on: May 11, 2023, 03:11:35 PM »
If i mask out areas in a laserscan, it will not aply changes to the mesh i build. I work bis 2.02 beta.

Dieter

Dieter

  • Full Member
  • ***
  • Posts: 209
    • View Profile
Re: Masks for laserscans not working
« Reply #1 on: May 22, 2023, 10:05:38 AM »
Is there a solution to the problem?

Dieter

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14890
    • View Profile
Re: Masks for laserscans not working
« Reply #2 on: May 22, 2023, 12:10:15 PM »
Hello Dieter,

Masks applied to the structured laser scans would be properly working since 2.0.2 build 16298.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Dieter

  • Full Member
  • ***
  • Posts: 209
    • View Profile
Re: Masks for laserscans not working
« Reply #3 on: May 22, 2023, 02:11:31 PM »
Thanks for the answer, but where i found this Beta?
Pls give me a link to download.

Dieter


Dieter

  • Full Member
  • ***
  • Posts: 209
    • View Profile
Re: Masks for laserscans not working
« Reply #5 on: March 13, 2024, 07:37:59 PM »
Hello,
I am of the opinion that when generating the dense point cloud, the masks in the laser scans do not work. According to the manual and also according to this thread, these should work by now! Can anyone confirm this for me? Tested with version 2.1.0.


Dieter