Forum

Author Topic: Question: extracting coordinates for a point  (Read 4604 times)

smicklethwaite

  • Newbie
  • *
  • Posts: 7
    • View Profile
Question: extracting coordinates for a point
« on: September 17, 2013, 12:09:20 PM »
A quick question from a relative beginner. Once I've produced a georeferenced model (using GCPs), is there a way of querying the model to extract co-ordinates of particular points or features?

Thanks

S

airmap3d

  • Jr. Member
  • **
  • Posts: 74
    • View Profile
Re: Question: extracting coordinates for a point
« Reply #1 on: September 17, 2013, 06:52:24 PM »
You have to export the results for use in GIS/CAD packages etc to be able to extract info. 

Photoscan 'basically' just gets the data ready for use on other software down the line.


smicklethwaite

  • Newbie
  • *
  • Posts: 7
    • View Profile
Re: Question: extracting coordinates for a point
« Reply #2 on: September 18, 2013, 05:07:06 AM »
Thanks, that's what I suspected but hoped there was another way. I may suggest this for future functionality, as it can help in the georeferencing of high resolution models, which are subsections of a larger low resolution model.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14854
    • View Profile
Re: Question: extracting coordinates for a point
« Reply #3 on: September 18, 2013, 08:56:45 AM »
Hello smicklethwaite,

You can place the marker in the point of interest and, leaving it unchecked in the Ground Control pane, find it's estimated coordintes in the corresponding tab on the pane.
Best regards,
Alexey Pasumansky,
Agisoft LLC

smicklethwaite

  • Newbie
  • *
  • Posts: 7
    • View Profile
Re: Question: extracting coordinates for a point
« Reply #4 on: September 20, 2013, 04:40:11 AM »
Great, thanks Alexey