Forum

Author Topic: Export model autonaming  (Read 3214 times)

Paulov

  • Newbie
  • *
  • Posts: 43
    • View Profile
Export model autonaming
« on: May 24, 2023, 05:54:59 PM »
Hi,

It would be very convenient if when exporting the mesh instead of blank name it had the same exact name that the mesh has inside the chunk.

Keep int mind that some of us are meshing point cloud scans that are already named so having the name already in place would be very convenient.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Export model autonaming
« Reply #1 on: May 24, 2023, 06:55:36 PM »
Hello Paulov,

You can use {chunklabel} macros in the filename field (in regula export or via batch process), if you want to get chunk label as a part of the output filename, for example:
Model_{chunklabel}_export.obj
Best regards,
Alexey Pasumansky,
Agisoft LLC

Paulov

  • Newbie
  • *
  • Posts: 43
    • View Profile
Re: Export model autonaming
« Reply #2 on: May 25, 2023, 11:49:18 AM »
I did not know that, tx, but still the chunk name, when you load a point cloud does not change I would love to have the mesh exported with the same exact thame the mesh has inside the chunk, which is the correct name derived from the source .las point cloud.