invisible boundary shapes

[JMR]

Dear Agisoft team.
Boundary shapes remain active in spite of the layer status. I wished to be able to keep different sets of boundaries stored in layers with different purposes, and thought I would be allowed to choose the active set of boundaries to produce desired deliverables with different extents according to the active layer while the remaining layers were disabled... but nope, it does not work. Boundary action override the layer status and the clipping was always the same. I think this is not the right behaviour.
Regards

Geobit

[Alexey Pasumansky]

Hello José,

Would it be helpful if it is possible to choose the layer for boundaries to be used next to "clip to boundary shapes" option in addition to all boundaries (that is default at the moment)?