Forum

Author Topic: Very 'wonky' buildings???  (Read 3992 times)

airmap3d

  • Jr. Member
  • **
  • Posts: 74
    • View Profile
Very 'wonky' buildings???
« on: October 13, 2013, 04:22:26 AM »
See attached image.

It is a tall structure (conveyor/train load out facility) that I am trying to get a more accurate ortho image of.  I have tried outputting the image with various different settings but so far haven't had a lot of success.

I understand that this type of thing is very difficult for photogrammetry, ie tall or suspended features, but is there a 'preferred' setting/workflow in Photoscan to achieve the best results?

Thanks.

bisenberger

  • Sr. Member
  • ****
  • Posts: 329
    • View Profile
    • Digital Mapping & Graphics
Re: Very 'wonky' buildings???
« Reply #1 on: October 14, 2013, 05:38:42 AM »
Did you try using arbitrary for surface type when building mesh?
Digital Mapping & Graphics LLC
https://digital-mapping.net/

airmap3d

  • Jr. Member
  • **
  • Posts: 74
    • View Profile
Re: Very 'wonky' buildings???
« Reply #2 on: October 14, 2013, 12:07:45 PM »
No, I hadn't tried that one yet.  I will run a few tests with 'arbitrary' and see how I go.

Thanks.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14816
    • View Profile
Re: Very 'wonky' buildings???
« Reply #3 on: October 14, 2013, 12:13:33 PM »
Hello airmap3d,

And can you share the screenshot of the geometry in the given area?
Best regards,
Alexey Pasumansky,
Agisoft LLC